Elgin Roof Pros provides professional fascia & soffit in Elgin, IL for residential and commercial properties across northern Kane and McHenry counties. Wrapping a fascia in aluminum coil is a twenty-minute solution that ends the argument about painting. On an Elgin district house it also buries the crown molding, the bed molding and the rafter tails that make the eave read as what it is. Both of those matter here.
The guidelines protect that detail from two directions. Gutter flashing must not conceal crown molding in the eaves, and gutter work should not result in removal of existing eave features. Coil stock over a molded cornice does both at once, and it hides rot rather than curing it so the wood behind keeps going for another decade unseen. Coil also traps moisture against the wood it covers, so the rot accelerates rather than stopping.
The manual also names a specific practice as not permitted, and it belongs on this page. Saw cutting the siding or shingle where a roof meets a vertical wall, to be filled in later with a tiny board, is banned outright. It is the fast way to trim a porch roof into a wall and it puts a horizontal cut line right where water runs. It is banned outright and for good reason.
So the repair we do is carpentry. Rotted fascia is scarfed out and replaced in matching profile stock, milled to the existing pattern where a stock profile will not do. Rafter tails get their ends cut back to sound wood and spliced. Boxed cornices come apart at the soffit board so the framing inside can be looked at, since that is where the rot usually started. Splices get glued and fastened, not simply butted together.
Primer on all six sides before anything goes up, back-priming included. Wood that is painted on the face and raw on the back will fail again in the same place. Cut ends get primed before they go up rather than after, and that is where a repair usually fails first. Six sides means six sides, cut ends included. It is ten extra minutes and a decade of service.
If the eave is plain, the house is post-war and nothing about it is protected, aluminum wrap is a perfectly reasonable thing to buy and we will install it. We just want you to know which house you have before you choose. Knowing which house you have is most of what this trade is. There is no shame in aluminum on a house that never had a cornice.
Our licensed and insured team brings the right materials and equipment to every job — sawn cedar shingles laid over a complete tear-off rather than split shakes, pressed metal shingle panels resoldered at the lap instead of stripped off, half-round hanging gutter with round leaders held to six inches or under, architectural laminate shingles in dark gray, black, brown or dark red, flat-seam metal panels soldered watertight on visible low-slope porch roofs, step flashing woven course by course in place of a saw kerf filled with trim — and backs the work with a written workmanship warranty. We serve Elgin and nearby communities including Carpentersville, West Dundee, East Dundee, Sleepy Hollow.
What We Handle
Everything our fascia & soffit in Elgin covers
One crew, one point of contact, and the full range of fascia & soffit work in Elgin, IL. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia repair Elgin IL
- soffit replacement
- rotted fascia board
- aluminum fascia wrap
- wood soffit repair
- cornice repair historic house
- eave rot repair
- exposed rafter tails
- boxed cornice repair
- soffit vent installation
- drip edge installation
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Elgin services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with sawn cedar shingles laid over a complete tear-off rather than split shakes, pressed metal shingle panels resoldered at the lap instead of stripped off, half-round hanging gutter with round leaders held to six inches or under, architectural laminate shingles in dark gray, black, brown or dark red, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Elgin job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in northern Kane and McHenry counties means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Elgin
Elgin Roof Pros covers Elgin and the surrounding communities of northern Kane and McHenry counties. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Carpentersville, IL — Kane County, population 37,983
- Fascia & Soffit in West Dundee, IL — Kane County, population 7,686
- Fascia & Soffit in East Dundee, IL — Kane County, part in Cook County, population 3,152
- Fascia & Soffit in Sleepy Hollow, IL — Kane County, population 3,214
- Fascia & Soffit in Gilberts, IL — Kane County, population 8,366
- Fascia & Soffit in Hampshire, IL — Kane County, population 7,667
Start on the Elgin Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Elgin Chooses Elgin Roof Pros
- ✓We count layers at the eave before pricing, because two or more means a full tear-off under the code Elgin enforces and no re-cover is available to you.
- ✓Certificate applications are drawn from the same scope we quote from, so the material and color on the approval match the material and color on your contract.
- ✓We do not order shingles before an approval is in hand, since any change to approved work has to be re-approved before materials are bought.
- ✓Our flashing is metal at every wall, valley, chimney and penetration, because the guideline manual specifically rejects caulk and bituminous coating as a substitute.
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Elgin follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Elgin gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Elgin, or request a quote and we'll get right back to you.